Kurzweil SP4-7 Betriebsanleitung PDF herunterladen (Seite 14)

Getting Started

StartUpDetails:TheRearPanel

2-2

Use Your SP4

1. Power up your SP4 ﬁrst, and then raise the MASTER VOLUME slider. The SP4 starts

up in Program mode by default. Press one of the Function buttons to the left of the

display to switch Modes.

2. If you hear distortion, reduce the gain on your mixing board, or use the pad (a switch

that decreases the input audio signal level, typically by 20dB) if it has one.

3. Scroll through the program list with the Previous and Next buttons under the display,

or with the dedicated Bank, Group Select, and Sound Select buttons, and try the SP4’s

many sounds. Take note that the User Bank is initially empty.

Start Up Details:

The Rear Panel

All of the connections take place on the rear panel of the SP4, pictured below:

The MIDI (IN and OUT) Ports

Use the MIDI ports to communicate with other MIDI modules and controllers. The OUT

port is the MIDI transmitting port, and the IN port is the MIDI receiving port.

The Pedal Jacks

Use the two pedal jacks to connect controller pedals to the SP4.

The Sustain (FOOT SW) Jack

Use the FOOT SW jack to connect a switch pedal. A switch pedal is a physical controller

typically used to control two-state (i.e., “on / off ”) parameters, such as sustain and mute

zone. Note that switch pedals can be used to control “continuous” parameters as well.

MIDI Ports

Pedal Jacks

USB Ports DC Power Jack

Audio Jacks Headphones Jacks

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 117 118

Keine Kommentare

Kurzweil SP4-7 Betriebsanleitung Seite 14